uckillo.blogg.se

1. #Do i need the boot.elf file for project m serial number
2. #Do i need the boot.elf file for project m zip file
3. #Do i need the boot.elf file for project m archive

I should mention now that my similar case opened with Xilinx on June 11 is still not solved yet.įinally, it would be nice if Xilinx Software would give a more "general" error type instead of the "specific" targeted error I received (DAP ACK error) in case the device is not powered properly. This approach is important for us here at Fermilab because we intend to use your TE0803 (or similar) and our custom designed carrier boards for some High Energy Physics application to be used both at Fermilab ( and at CERN ( Thank you very much for your support and quick debugging. I was also able, using my initial project, which dos not use any of your board files, to Launch on Hardware in SDK my own Hello World. Now I was able, using your test_board_buid_09 and the BOOT.bin and zynqmp_fsbl_flash.elf you gave to me to do the following: program flash from Vivado boot from flash the TE0803 board and see the message on a terminal do my own Hello World elf file and lunch it from SDK. The bare FPGA draws about 0.6A and when you program and run it goes to ~1.3A. That was the key, now it's working, thank you.

You need ARM initialisation to get access to flash or to activate PS-PL CLKs(from ZynqMP IP) for example. You can configure FPGA with Bitfile also if the PS (ARM) has some problems.TET0808 and TEBT0808 is the same, this board was renamed only.Reboot with the button from the XMOD (TE0790) (second FSBL output should appear and Hello TE0803 in endless loop)ĭoes this work? If not, can you tell me the Status of the ERR_OUT and ERR_STATUS and DONE LED (after reboot (step ).Program and wait until it's finished (You should see FSBL output on the UART console).

#Do i need the boot.elf file for project m zip file

#Do i need the boot.elf file for project m serial number

I've tried to reproduce it on my place, but here it works (I've another assembly version than you, but the steps are the same).Ĭan you tell me which external power supply you use? Is there a current limit?Ĭan you send me the serial number of your TE0803? You can send this number also to instead to write this here.Ĭan you try to start my application from flash. Please take a look, maybe I'm missing other settings, like, do I need to create any special Isolation for the DAP port?ĬONFIG.PSU_DDR_RAM_HIGHADDR \

#Do i need the boot.elf file for project m archive

Invalid DAP ACK value: 4" The following shows all my DDR settings and the attachment archive contains the board file te0803_bd_ddr_fgrm4.tcl (generated with write_bd_tcl). Unfortunately I get the same error in SDK "Memory read error at 0xFD080030. The DDR settings were as you say, except the refresh rate was x1, now it is x4.